Problem Possible solution
Make sure that the packaging and/or the transit bolts
are removed. Refer to 'Installation'.
Add more laundry in the drum. The load may be too
small.
The appliance fills
with water and drain
immediately.
Make sure that the drain hose is in the correct position.
The hose may be too low.
The cycle is shorter
than the time dis-
played.
The appliance calculates a new time according to the
laundry load. See the ‘Consumption Values’ chapter.
The cycle is longer
than the time dis-
played.
An unbalanced laundry load increases the duration
time. This is a normal behaviour of the appliance.
The washing results
are not satisfactory.
Increase the detergent quantity or use a different de-
tergent.
Use special products to remove the stubborn stains be-
fore you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the Serv-
ice.
13. TECHNICAL DATA
Dimensions Width / Height / Depth 600 / 850 / 605 mm
Total depth 640 mm
Electrical connection: Voltage
Overall power
Fuse
Frequency
230 V
2200 W
10 A
50 Hz
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, ex-
cept where the low voltage equipment has no pro-
tection against moisture
IPX4
Water supply pressure Minimum 0,5 bar (0,05 MPa)
Maximum 8 bar (0,8 MPa)
Water supply
1)
Cold water
Maximum load Cotton 7 kg
ENGLISH 23
