Problem Possible cause Solution
Audible or visual alarm is on. The cabinet has been re-
cently switched on or the
temperature is still too
high.
Refer to "Door Open Alarm"or
"High Temperature Alarm".
The temperature in the ap-
pliance is too high.
Refer to "Door Open Alarm"or
"High Temperature Alarm".
The door is left open. Close the door.
The temperature in the ap-
pliance is too high.
Contact a qualified electrician
or contact the nearest Author-
ized Service Centre.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the lamp".
The compressor operates
continually.
Temperature is set incor-
rectly.
Refer to "Operation" chapter.
Many products were put in
at the same time.
Wait some hours and then
check the temperature again.
The room temperature is
too high.
Refer to climate class chart on
the rating plate.
Products placed in the ap-
pliance were too warm.
Allow products to cool to
room temperature before stor-
ing.
The door is not closed cor-
rectly.
Refer to "Closing the door".
Water flows on the rear
plate of the refrigerator.
During the automatic de-
frosting process, frost
melts on the rear plate.
This is correct.
Water flows inside the wine
cellar.
The water outlet is clog-
ged.
Clean the water outlet.
Products prevent that wa-
ter flows into the water col-
lector.
Make sure that products do
not touch the rear plate.
DEMO appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the Alarm pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
If the advice does not lead
to the desired result, call the
nearest brand-mark service.
ENGLISH 11
