Installation
Step 8: Take the electrical harness (EPVH-10-100) that will commu-
nicate with the Power vent and pass the cable through the slot in the
rough box. Make sure the nut for the strain relief is inside the box and
the strain relief is outside the box.
Figure 2i.
Figure 2j. Removing control cable cover
Figure 2k.
Step 10: Push the molex connector through the hole in the electrical
cover until it clicks into place.
Figure 2l.
Step 11: Secure the electrical cover back down with the six screws
making sure the control cable curls up safely.
Figure 2m.
Step 12: Pass the vent pipe through the rough in box so it extends
6 1/2 inches into the rough in box.
Step 9: Reinstall the strain relief plate underneath the strain relief nut
and screw the strain relief plate down. Then tighten strain relief nut.
Click
Figure 2n.
Page 6
XG0517 - 070714
6 1/2 "
PVHEX58-300 & PVHEX510-300 Horizontal Power Vent
