GE Brand's Products

Installation Instructions

STEP 6 SECURE UNIT TO WALL

7KH´/µURGVFDQEHIRXQGLQWKHXSSHUOHIWDQGULJKW

corners of the unit in the access compartment.

Look through the access compartment to make

sure the rods line up with the anti-tip bracket.

7KHUHDUHZDVKHUVDQGDKDLUSLQFRWWHUSHUURG

Remove the washers and hair pin cotter from the end

of the rod.

5RWDWHDQGPRYHWKH´/µURGLQWRWKHVORWLQWKHDQWLWLS

bracket tab. Once it is in the slot, rotate the “L” rod

VRWKHKRRNSRUWLRQLVSRLQWLQJGRZQ7KHKROHV

at the front end of the rod should be in a vertical

position. Do this to both sides.

3XOORXWRQWKHHQGRIWKHURGWRPDNHVXUHLWLVVHFXUH

in the bracket.

/RFDWHWKHKROHRQWKHURGWKDWLVFORVHVWWRWKHXQLW

A hair pin cotter will be put through this hole to secure

the rod. If this hole appears to be too far away for

a snug fit against the unit, add the washers one

at a time until the pin will fit tightly into the hole.

$OLJQWKHVWUDLJKWVHFWLRQRIWKHSLQZLWKWKHKROHIURP

the underside of the rod. Push the pin up until it snaps

into position. Pliers may be used. NOTE:7KHKDLUSLQ

cotter must be vertical when this step is completed

to ensure the “L” rod is engaged in the bracket.

&KHFNWKHURGIRUWLJKWQHVVE\SXOOLQJIRUZDUG

If the rod moves, remove the hair pin cotter and

place another washer on the rod. Reinsert the pin.

5HSODFHWKHJULOOHSDQHO