• Obey the maximum load volume of 6 kg (refer to the “Programme chart”
chapter).
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• The operating water pressure (minimum and maximum) must be between 0,5
bar (0,05 MPa) and 8 bar (0,8 MPa)
• The ventilation openings in the base (if applicable) must not be obstructed by
a carpet.
• The appliance is to be connected to the water mains using the new supplied
hose-sets. Old hose sets must not be reused.
Safety instructions
Installation
• Remove all the packaging and the transit bolts.
• Keep the transit bolts. When you move the appliance
again you must block the drum.
• Do not install or use a damaged appliance.
• Do not install or use the appliance where the temper-
ature is less than 0 °C or where it is exposed to the
weather.
• Obey the installation instruction supplied with the ap-
pliance.
• Make sure that the floor where you install the appli-
ance is flat, stable, heat resistant and clean.
• Do not install the appliance where the appliance
door can not be fully opened.
• Always be careful when you move the appliance be-
cause it is heavy. Always wear safety gloves.
• Make sure that there is air circulation between the
appliance and the floor.
• Adjust the feet to have the necessary space between
the appliance and the carpet.
Electrical connection
Warning! Risk of fire and electrical shock.
• The appliance must be earthed.
• Make sure that the electrical information on the rat-
ing plate agrees with the power supply. If not, con-
tact an electrician.
• Always use a correctly installed shockproof socket.
• Do not use multi-plug adapters and extension ca-
bles.
• Make sure not to cause damage to the mains plug
and to the mains cable. Should the appliance power
supply cable need to be replaced, this must be car-
ried out by our Service Centre.
• Connect the mains plug to the mains socket only at
the end of the installation. Make sure that there is
access to the mains plug after the installation.
• Do not pull the mains cable to disconnect the appli-
ance. Always pull the mains plug.
• Do not touch the mains cable or the mains plug with
wet hands.
• This appliance complies with the E.E.C. Directives.
Water connection
• Make sure not to cause damage to the water hoses.
• The appliance is to be connected to the water mains
using the new supplied hose-sets. Old hose sets
must not be reused.
• Before you connect the appliance to new pipes or
pipes not used for a long time, let the water flow until
it is clean.
• The first time you use the appliance, make sure that
there is no leakage.
Use
Warning! Risk of injury, electrical shock, fire,
burns or damage to the appliance.
3
