Positioning and levelling
Level the appliance by raising or lowering the feet.
Depending on the model, the appliance can have four
adjustable feet, or two front-adjustable feet and two
back fixed feet.
The appliance MUST be level and stable on a flat
hard floor. If necessary, check the setting with a spirit
level. Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and dis-
placement of the appliance during operation.
Repeat the levelling action, if the appliance is not lev-
el and stable.
Water inlet
Connect the hose to a
tap with a 3/4” thread.
35°
45°
Loosen the ring nut to angle the hose to the left or
right depending on the position of your water tap. Do
not place the inlet hose downwards. After position-
ing the inlet hose, be sure to tighten the ring nut
again to prevent leaks.
Water drainage
Firstly form a hook in the end of the drain hose using
the plastic hose guide supplied with the appliance .
The end of the drain hose can be positioned in four
ways:
• Hooked over the edge of a sink using the plas-
tic hose guide.
8
