Cleaning the water inlet filters
Important! If the appliance doesn't fill, it takes a long
time to fill with water, the starting button flashes red or
the display (if available) shows the relevant alarm (see
chapter "What to do if..." for more details), check if the
water inlet filters are blocked .
To clean the water inlet filters:
• Turn off the water tap.
• Unscrew the hose
from the tap.
• Clean the filter in the
hose with a stiff brush.
• Screw the hose back onto the tap. Make sure the
connection is tight.
• Unscrew the hose
from the appliance.
Keep a towel nearby
because some water
may flow.
• Clean the filter in the
valve with a stiff brush
or with the piece of
cloth.
• Screw the hose back to the appliance and make
sure the connection is tight.
• Turn on the water tap.
What to do if…
The appliance does not start or stops during operation.
Certain problems are due to lack of simple mainte-
nance or oversights, which can be solved with the help
of the indications described in the charts, without calling
out an engineer.
During appliance operation it is possible that the red
pilot light of the button 7 flashes and one of the indica-
tor pilot lights illuminates to indicate that the appliance
is not working.
Before contacting your local Service Centre, please
carry out the checks listed below.
Fault code and malfunction Possible cause - Solution
oiggavaL
azzedibr
oM
5
iuq
c
aics
i
R
olcic eniF
Avvio/Pausa
The light of button 7 flash-
es and the light 6.1 illumi-
nates:
Problem with the water
supply
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve filter are blocked
• Clean the water inlet filters (read "Cleaning the water inlet filters" for more de-
tails).
22
