33
ENGLISH
Use
1. Detergent dispenser drawer
Programme option buttons
Depending on the programme, different option
buttons can be combined.
When these buttons are pressed, the corresponding
lights come on. When they are pressed again, the
lights go off.
If an incompatible option with the selected
programme has been chosen, the corresponding
light flashes for about 2 seconds.
The option buttons: PRELAVADO or
BLANQUEANTE; REDUCCION CENTRIFUGADO;
MEDIA CARGA and ANTIARRUGAS must be
selected after the required programme has been
chosen, by turning the programme selector (see
section 8) and before starting the machine, by
pressing INICIO / PAUSA button.
2. PRELAVADO OR
BLANQUEANTE button
By pressing this button you have the possibility of
choosing between the following options:
• PRELAVADO option: Adds a pre-wash phase at
the start of the cycle with water heating to 30° C.
In COTTON and SYNTHETIC cycles, performs a
short spin before passing to the washing phase.This
option cannot be selected for WOOL.
• BLANQUEANTE option: Runs water through the
bleach compartment at the beginning of the first
rinse in COTTON cycles.
Press the button as many times as you need to get
the required option. The corresponding light will
come on.
IF BOTH LIGHTS (PRELAVADO AND
BLANQUEANTE) ARE NOT ILLUMINATED, THE
PROGRAMME WILL RUN WITHOUT EITHER
PREWASH OR BLEACH.
3. REDUCCION CENTRIFUGADO
button
By depressing this button you can reduce the final
and the intermediate spin speeds as follows:
Cotton programmes: from 1000 to 500 r.p.m.
(LC1080E) and from 800 to 450 r.p.m. (LC880E).
Synthetics and wool programmes: from 900 to
450 r.p.m. (LC1080E) and from 800 to 450 r.p.m.
(LC880E).
Delicates programmes: from 700 to 450 r.p.m.
(Both models).
4. MEDIA CARGA button
Select this button to reduce water consumption on
the rinse cycle when washing a smaller load of
cottons or linens (maximum load size = 2.25 kg).
The machine will perform 2 rinses instead of 3.
5. ANTIARRUGAS button
By selecting this option, the water of the last rinse is
not drained, in order to prevent the fabrics from
wrinkling. The corresponding light will remain lit
during the entire washing cycle. When the
programme has finished, FIN light will also illuminate.
To drain the water follow these three steps:
A) Turn the programme selector dial to “
O”.
B) Select DESCARGA (DRAIN) or
CENTRIFUGADO (SPIN) programme.
C) Press INICIO / PAUSA button.
6. INICIO / PAUSA button
After selecting the required programme, by the
programme selector (see section 8), press this
button to start the machine; the corresponding
light stops flashing and will keep lighting until
the programme finishes.
To interrupt the running programme, depress
INICIO / PAUSA button: the corresponding
light starts to flash.
To restart the programme from the point at
which it was interrupted, press INICIO / PAUSA
button again.
Control panel
