Produits de la Marque ZANKER

Installation

Unpacking

All transit bolts and packing must be removed before

using the appliance.

You are advised to keep all transit devices so that they

can be refitted if the machine ever has to be transpor-

ted again.

After removing all the

packaging, carefully lay

machine on it's back to

remove the polystyrene

base from the bottom.

Remove the power sup-

ply cable and the hoses

from the hose holders on

the rear of the appliance.

Unscrew the three bolts

with the supplied span-

ner.

Slide out the relevant

plastic spacers.

Open the porthole and

remove the polystyrene

block fitted on the door

seal.

Fill the smaller upper

hole and the two large

ones with the corre-

sponding plastic plug

caps supplied in the bag

containing the instruction

booklet.

Positioning

Install the machine on a flat hard floor. Make sure that

air circulation around the machine is not impeded by

carpets, rugs etc. Check that the machine does not

touch the wall or other kitchen units. Level the washing

machine by raising or lowering the feet. The feet may

be tight to adjust as they incorporate a self locking nut,

but the machine MUST be level and stable.

Any necessary adjustment can be made with a span-

ner.

Accurate levelling prevents vibration, noise and dis-

placement of the machine during operation. Never

place cardboard, wood or similar materials under the

machine to compensate for any unevenness in the

floor.

If necessary, check the

setting with a spirit level.

Water inlet

Warning! This appliance must be connected to

a cold water supply