6
ES
U
AP
/
TRATS
Start the programme by pressing the button 6
•To start the selected programme, press the button 6 , the corre-
sponding green pilot light stops flashing. The pilot light 7.1 illumi-
nates to indicate that the appliance starts operating and the door is
locked. If you have chosen a delayed start, the appliance will begin
the countdown.
•
To interrupt a programme which is running, press the button 6 :
the corresponding green pilot light starts flashing. It is possible
to change some options of a running programme before the pro-
gramme carries them out.
•
To restart the programme from the point at which it was interrup-
ted, press the button 6 .
• After the programme has started the door is locked. If, for any rea-
son, you need to open the door , set firstly the appliance to
PAUSE by pressing the button 6 . After a few minutes it will be pos-
sible to open the door.
If the door remains locked, this means that the appliance is already
heating or that the water level is too high. In any case, do not try to
force the door!
If you cannot open the door but you need to open it you have to
switch the appliance off by turning the selector dial to
. After a
few minutes the door can be opened ( pay attention to the water
level and temperature! ). After closing the door, it is necessary to
select the programme and options again and to press the button 6 .
7.1
7.2
7.3
Indicator pilot lights
BETRIEB
EXTRA SPÜLEN
ENDE
•
When you start the programme by pressing the button 6 , the wash-
ing phase pilot light ( 7.1 ) illuminates. This means that the appli-
ance is operating.
•
The additional rinses pilot light ( 7.2 ) illuminates when the appli-
ance performs an extra rinse.
•
When the programme has finished the end cycle pilot light ( 7.3 )
comes on.
At the end of the programme
The appliance stops automatically. The pilot light of
the button 6 and the pilot light corresponding to the
just finished washing phase go off. The light 7.3 illumi-
nates.
If a programme or an option that ends with water left
in the tub has been selected and the door remains
locked to indicate that the water must be emptied out
before opening the door.
Follow the below instructions to empty out the water:
•
Turn the programme selector dial to
.
• Select the draining or spinning programme.
• Reduce the spin speed if needed, by pressing the
relevant button.
•
Press the button 6 .
At the end of the programme, the door can be now
opened. Turn the programme selector dial to
to
switch the appliance off.
Remove the laundry from the drum and carefully
check that the drum is empty. If you do not intend to
carry out another wash, close the water tap. Leave
the door open to prevent the formation of mildew and
unpleasant smells.
16
