27
Water inflow
A 1.50 m long pressure hose is supplied with the ap-
pliance.
If a longer water inlet hose is required, only original
hoses are to be used. The Customer Care Depart-
ment stocks hose kits of different lengths.
3 Sealing rings are either inserted in the nuts of
the threaded hose fitting or are included as
spare parts . Do not use any other type of
sealing rings.
Important! All threaded hose fittings must only be
tightened by hand.
1. Connect the hose with the right-angle connector to
the machine.
Important! Do not position the inlet hose vertically
downwards. Position it to the right or the left as
shown in the illustration.
2. Connect the hose with the straight connector to a
water tap with an R ¾ (inch) screw thread.
3. To tighten or loosen the threaded hose fitting, only
the metal nuts must be turned. When doing this,
keep a firm hold on the housing of the safety valve
with one hand, so that it does not turn at the same
time.
Important! To tighten or loosen the threaded hose
fitting, never turn the housing of the safety valve,
as otherwise the inner hose will be damaged.
4. Open the water tap slowly and check all connec-
tions for water tightness.
