PAGE 8
FOR SERVICE TECHNICIAN’S USE ONLY
DO NOT REMOVE OR DESTROY
AUTOMATIC TEST MODE — See page 4 to access Automatic Test Mode. = ON
Press the START button to begin the Automatic Test.
IMPORTANT: Lid must be closed and locked to perform Automatic Test.
FUNCTION
Recommended Procedure
(Status LED names may vary between makes and models)
WASH
RINSE
SPIN
DONE
LID LOCK
LID WILL LOCK
On
COLD VALVE WILL ACTUATE
On
HOT VALVE WILL ACTUATE
On
RESERVED FOR FUTURE DEVELOPMENT
On
RESERVED FOR FUTURE DEVELOPMENT
On
RESERVED FOR FUTURE DEVELOPMENT
On
HOT & COLD VALVE WILL ACTUATE
On
SHIFTER MOVES TO AGITATION POSITION
On
MOTOR AGITATES
On
DRAIN PUMP WILL ACTUATE
On
SHIFTER MOVES TO SPIN POSITION
On
MOTOR SPINS
On
LID REMAINS LOCKED UNTIL WASHER SENSES A STOPPED
BASKET
On
LID WILL UNLOCK AND CYCLE COMPLETES
STATUS LEDs
If motor does not agitate, go to Manual Test: Gentle or Heavy Agitation, page 9.
If water is not draining, go to Manual Test: Drain, page 9.
If basket is not turning, go to Manual Test: Low or High Spin, page 9.
Washer will pause for 5 seconds.
Washer will pause for 5 seconds.
Hot & cold water valves will actuate for the specified time period.
If motor does not agitate, go to Manual Test: Gentle or Heavy Agitation, page 9.
Motor must be at “0” RPM. If lid does not lock, go to Manual Test: Lid Lock, page 9.
If water is not present, or temperature is wrong, go to Manual Test: Cold Valve, page 9.
If lid does not unlock, go to Manual Test: Lid Lock, page 9.
If water is not present, or temperature is wrong, go to Manual Test: Hot Valve, page 9.
Washer will pause for 5 seconds.
Basket must stop spinning (0 RPM) before test continues to next phase. Time for basket to stop spinning may vary
from 30 seconds up to 2 minutes.
If basket is not turning, go to Manual Test: Low or High Spin, page 9.
Est. TIME
In Seconds
1
5
5
5
5
5
45
~5-15
10
~30-40
~5-15
10
~30-45
1
~3 min
1
2
21
4
4 1
42
421
8
8 1
8 2
8 2 1
84
84 1
842
