GB 8
PROGRAMME SELECTION
Select the programme
1.
Turn the
programme selector knob
to the desired programme.
The remaining time display (depending on the model) shows the approximate duration of the chosen
programme (in hours and minutes) and the pilot lamp of the
“Start/Pause”
button flashes.
The readout of temperature and predefined spin speed corresponding to the selected programme is
displayed.
2.
The preselected temperature can be altered by pressing the “+” or “-” button (depending on model).
3.
Select an option
When you select an option, the corresponding indicator lamp lights up, unless the combination
of the programme, the additional options and the temperature is not possible.
Start Delay
(depending on model)
The “Start Delay” is an option which delays the start of the programme at the consumer’s convenience
and enables the use of off-peak electricity (for example late at night).
Select programme, temperature and options.
•
Press the “Start Delay” button to select the delay time of 1 to 19 hours;
•
Press the “
Start/Pause
” button. The indicator light of the “
Start/Pause
” button lights up and the
lamp of the “Start Delay” button flashes.
•
The time delay indication disappears when the programme starts and is replaced by the remaining
time.
•
The number of hours preselected can be reduced later by pressing the “Start Delay” button again.
To cancel the “Start Delay”.
•
Turn the programme selector to the “ ” position.
•
Reselect the desired programme and options and press the
“Start/Pause
” button.
Programme start
Turn on the tap and press the
“Start/Pause”
button. The indicator light of the
“Start/Pause”
button
lights up.
After starting the programme, the sequence indication signals the Wash, Rinse and Spin phases.
Note:
If there is a power interruption or if the appliance is disconnected during the cycle, the programme
will start again at the point where it was interrupted.
Lid lock
For reasons of safety, the lid is locked during certain phases of the cycle.
At the end of the cycle or during an interruption, the lid unlocks automatically after about 1 minute.
Programme end
•
The remaining time indicator shows “0:00” and all the lights of the programme sequence indication are off.
1.
Turn the programme selector to the “ ” position.
2.
Turn off the tap.
3.
Open the lid and drum flaps and unload the machine.
Change the programme or options during the cycle
1.
Select the new programme with the programme selector. If necessary, select the additional options and the spin
speed. The indicator lamp of the “
Start/Pause
” button flashes.
Note:
the “Start Delay” and “Prewash” options cannot be selected after a change of programme.
2.
Press the “
Start/Pause
” button. The newly selected programme will start at the washing position
where the previous programme was interrupted.
Note
: Do not add detergent for the new programme.
Programme interruption/pause
If, for any reason, you want to interrupt the programme for a certain time and continue it later:
1.
Press the “
Start/Pause
” button. The pilot lamp flashes.
2.
After the desired pause, press the “
Start/Pause
” button again.
Cancel programme
If the current programme has to be terminated prematurely and cancelled, proceed as follows:
1.
Put the programme selector on “Drain”.
2.
Press the “
Start/Pause
” button to start the “Drain” programme.
4gb10037.fm Page 8 Thursday, August 5, 2004 6:55 PM
