70
RECOVERING AN OBJECT THAT FALLS
BETWEEN THE DRUM AND THE TUB
If accidentally an object falls between the drum and
the tub you can recover it thanks to a removable
plastic lifter:
1.
Unplug the appliance.
2.
Remove the laundry from the drum.
3.
Close the drum flaps and turn the drum to the
opposite of the flaps.
4.
Press the plastic tip while sliding the plastic lifter
from left to right.
The plastic lifter will fall into the drum.
5.
Open the drum: through the hole inside the
drum you can recover the object.
6.
Refit the plastic lifter from inside the drum:
Position the plastic tip above the hole on the
right side of the drum.
Then slide the plastic lifter from right to left until
it clips.
7.
Plug in the appliance to the electrical outlet.
This appliance is equipped with safety functions
which detect faults at an early stage and react
appropriately.
Often, however, the faults detected are small
enough to be solved in a matter of minutes.
The appliance will not start, no lamp
lights up.
Check whether:
•
the appliance is plugged in;
•
the wall socket is functioning correctly (use a
table lamp or similar).
The appliance will not start, but the
“Start” lamp is flashing.
Check whether:
•
the appliance lid is properly closed;
•
a programme has been selected and the
programme is started.
•
the water tap is open.
The appliance stops during the
programme.
Check whether:
•
the “Rinse Hold” button is flashing, terminate
this option by pressing the button again;
•
another programme has been selected.
Reselect the desired programme and press the
“Start/Pause” button;
•
“Start/Pause” lamp is flashing. Press “Start”
button.
•
the door was opened and the “Start/Pause”
button is flashing. Press it again.
•
Safety system of the appliance was activated.
See fault description table on this page.
Detergent and additive product residues
in dispenser at end of wash.
Check whether:
•
the siphon is correctly installed and clean (see
“Maintenance and Cleaning” / “Detergent and
Additives”);
•
enough water is being supplied. The mesh
filters could be clogged (see “Maintenance and
Cleaning” / “Water Hose Mesh Filters”).
The appliance vibrates during the spin
cycle.
Check whether:
•
the appliance is level and solidly installed on all
feet (see “Installation instructions”);
•
the transport screws and transport bar have been
removed.
Before starting up the appliance, the transport
screws and the transport bar must be removed
(see Installation Instructions).
Final spin results are poor.
•
the appliance has an imbalance detection and
correction system. If individual heavy articles are
loaded (bathmat, bathrobe, etc.) this system may
reduce the spin speed automatically to protect
the appliance. It may even interrupt the spin cycle
altogether, if the imbalance is too great after
several spin starts;
•
if the laundry is too wet at the end of the cycle,
add more articles of laundry to balance the load
and repeat the spin cycle;
•
excessive foam formation may prevent spinning.
Use less detergent.
Check whether:
the pump impeller is obstructed (see “Removing the
Foreign Body Trap”) Fault “Waterstop”.
MAINTENANCE AND CLEANING
TROUBLESHOOTING GUIDE
