Dil ID: 7
Dil Adı: french
Dil Kodu: fr2tayfun Produits de la Marque Whirlpool
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



6
WATER SUPPLY
Water supply: cold water only
Tap: 3/4 threaded hose connection
Pressure: 10-100 N/cm² (1-10 bar).
Should the appliance be installed in a room
which is subject to extremely low temperatures,
you need to empty water at the end of each wash
programme. Please follow the instructions given
in the chapter titled Draining Residual Water
and disconnect the water inlet hose.
WATER INLET HOSE(S)
1.
The mesh filter supplied with the appliance
must be inserted in the connection between
the supply hose and the tap.
2.
Carefully screw the hose connection to the
tap preferably by hand. Make sure there are
no kinks in the hose and that it is not crushed.
3.
Check water-tightness of tap and appliance
connections by turning the tap completely on.
If the hose is too short, replace it with a
suitable length of pressure resistant hose
(10 bar min., EN 50065 approved type).
The appliance can be connected without a
non-return valve.
Install the appliance in accordance with
regulations of your local water company.
For Great Britain & Ireland only:
Water inlet:
- hot (see
A
) fill hose;
- and cold (see
B
) fill hose.
The warm water inlet temperature must not
exceed 60° C.
WATER STOP ANTI-FLOODING SYSTEM
(depending on model)
:
Screw the threaded connection with the filter
into the union nut on the water tap. Open the
water tap fully and check the water tightness
of the connection point.
The appliance must not be connected to the
mixing tap of a non-pressurized water heater!
The inlet hose (see arrow
C
) and the plastic
enclosure at the tap connection contain
electrical components.
Do not cut the hose and do not immerse the
plastic enclosure in water.
If the flexible hose is damaged, unplug the
appliance from the mains immediately.
If the hose is too short, replace it with a 3 m Water
Stop hose (available from After-Sales Service or
from your dealer). This operation must be carried
out exclusively by a licensed electrician.
INSTALLATION INSTRUCTIONS
C