6
CLEANING AND
MAINTENANCE
Never use steam cleaning
equipment.
Wear protective gloves for
cleaning and maintenance.
The appliance must be
disconnected from the power
supply before any maintenance
operation.
on a sheet of plywood at least
60 x 60 cm wide/ deep and
at least 3 cm thick which is
secured to the oor.
Use only new hoses to connect
the appliance to the water
supply. The old hose-sets
should not be reused.
Move the appliance without
lifting it by the worktop.
Connect the water inlet
hose(s) to the water supply
in accordance with the
regulations of your local water
company.
For models dedicated only for
cold water: Do not connect to
the hot water supply.
For models with hot ll: the
hot water inlet temperature
must not exceed 60 °C.
Make sure that the ventilation
openings in the base of
your washing machine (if
available on your model) are
not obstructed by a carpet or
other material.
The supply water pressure
must be in range 0.1 -1 MPa.
If you want to place a dryer
on top of your washing
machine, rst contact our
After-Sales Service or your
specialist dealer to verify if
this is possible. This is only
admitted if the dryer is xed
on the washing machine by
using an appropriate stacking
kit available through our After-
Sales Service or your specialist
dealer.
ELECTRICAL WARNINGS
For installation to comply with
current safety regulations,
an omnipolar switch with
minimum contact gap of
3 mm is required and the
appliance must be earthed.
If the power cable is damaged,
replace with an identical one.
The power cable must only
be replaced by a qualied
technician in compliance with
the manufacturer instruction
and current safety regulations.
Contact an authorized service
center.
If the tted plug is not suitable
for your socket outlet, contact
a qualied technician.
The power cable must be
long enough to connect the
appliance, once tted in its
housing, to the main power
supply. Do not pull the power
supply cable.
Do not use extension leads,
multiple sockets or adapters.
Do not operate this appliance
if it has a damaged mains
cord or plug, if it is not
working properly, or if it has
been damaged or dropped.
Keep the cord away from hot
surfaces.
The electrical components
must not be accessible to the
user after installation.
Do not touch the appliance
with any wet part of the body
and do not operate it when
barefoot.
CORRECT USE
Do not exceed the maximum
load allowed. Check the
maximum load allowed in the
programme chart.
Turn o the tap when not in use.
The water in the appliance is not
potable.
Do not use any solvents
(e.g. turpentine, benzene),
detergents containing solvents,
scouring powder, glass or
general purpose cleaners,
and ammable uids; do not
machine wash fabrics that have
been treated with solvents or
ammable liquids.
