111
DRAIN HOSE
• Drain hose connection to water outlet.
1. Unhook the drain hose from the left clip;
see arrow(A).
Important:
Do NOT loosen the drain hose connection;
see arrow (B), otherwise there is the risk of
leakage (danger of scalding with hot water).
2. Fit the drain hose either to the siphon or hook
it over the edge of a sink or bath tub with the
“U” bend. Small hand basins are not suitable.
3. Minimum drain height: 60cm.
Maximum U-bend drain height: 90cm.
4. If you need to add an extension, use a
flexible hose of the same type and secure the
union with screw-on hose clips. Maximum
overall drain hose length 2.5m.
Important:
Make sure that there are no kinks in the drain
hose run and take precautions against it falling
while the appliance is running.
CONNECTION TO THE MAINS
• Observe local utility company regulations.
• The connection must be made with a
correctly installed, earthed and insulated
socket.
• The system must be earthed.
The manufacturer declines all responsability
for injury to persons or pets and damage to
property caused by disregarding the above
instructions.
• The data concerning voltage, consumption
and necessary fuse are supplied on the
inside of the appliance door.
• The mains connection cable may only be
replaced by a qualified electrician.
• The appliance conforms to European safety
regulations, ECdirective93/68/EWG and
EN60555.
• Do not use extension leads or multiplugs.
INSTALLATION
00033-gb.fm5 Page 111 Thursday, May 11, 2000 4:52 PM
