9
IMPORTANT INFORMATION ABOUT THE WASHING MACHINE FUNCTION
1. Your washing machine does not start immediately
after switching it on - but it begins to fill water only
after 15-20 seconds, that is the time needed for the
electric door locking. The drum starts rotating only
after filling certain amount of water.
2. When washing cotton and resistant synthetics, the
program does not end after final spinning finish but
the drum goes on reversing up to circa 3 min (its
rotation alters in one and another direction), which
helps to release the laundry after spinning.
3. Spinning has an interrupted start-up - the drum
starts and stops running several times - it is so
called interval spinning with an increased
spinning efficiency.
4. Front part of the top frame and the cabinet can
get warm from the electric door lock, which is
not a fault.
INTERRUPTING THE WASH PROGRAMME
If you want to change selected programme
1. Select a new programme using the selector knob
If you want to add another piece of laundry, you
can interrupt the washing cycle at any time:
1. Switch OFF the washing machine by adjusting
timer knob to position STOP.
2. The door is electrically closed during the whole
washing cycle, so you must wait oneminute
approx. for the door safety device to release.
3. Open the lid, the inner door and the drum flaps.
Add the items to the wash load..
4. Close the drum flaps, the inner door and the lid.
5. The timer knob adjust to the same position as it
was before working cycle interruption. Washing
machine will continue in selected work cycle.
End of the wash programme
The programme is completed when the programme
selector knob stop on a STOP position.
Turn off the water tap and disconnect the machine from
the mains.
The safety device will keep the door locked at the end
of the wash cycle for approximately one minute.
1. Open the machine lid, the inner door and drum flaps .
2. Remove the laundry, pay attention not to drop small
items between the tub and the cabinet.
