18
EN
Adding extra crockery
Turn the knob to the OFF position and open the door,
taking care to avoid the escaping steam, and place the
crockery inside the dishwasher. Turn the knob back to
the ON position: the cycle starts from the point at which it
was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if there is a
power cut, the cycle stops. It starts again from the point at
which it was interrupted once the door has been shut or the
electricity supply is restored.
A
B
D
C
Start-up and use
* Only available in selected models.
Starting the dishwasher
1. Turn the water tap on.
2. Turn the knob in a clockwise direction until it reaches
the ON position: the indicator light will illuminate.
3. Open the door and measure out a suitable amount of
detergent
(see below)
.
4. Load the racks
(see Loading the racks)
and shut the
door.
5. Select the programme by turning the WASH CYCLE
SELECT knob in a clockwise direction: align the notch
on the knob with the number or symbol representing the
desired wash cycle.
6. Select the wash options
(see below)
.
7. A beep will confirm the start of the wash cycle and the
WASH CYCLE PHASE indicator lights display the wash
cycle status: Pre-wash, Wash, Rinse, or Drying.
8. At the end of the cycle two short beeps will sound and
the indicator light corresponding to the drying phase will
flash. Turn the SELECT WASH CYCLE knob in an
anticlockwise direction until it reaches the RESET
position. Switch off the appliance by turning the knob in
an anticlockwise direction until it reaches the OFF
position. Shut off the water tap and remove the plug from
the electrical socket.
9. Open the door and wait for a few minutes before
removing the crockery inside, in order to avoid burns.
Unload the racks, beginning with the lower level.
Modifying a wash cycle in progress
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided that
it has only just begun: turn the SELECT WASH CYCLE
knob in an anticlockwise direction until it reaches the
RESET position. After a few seconds, 4 beeps will sound
and the WASH CYCLE PHASE indicator light will switch
off, indicating that all settings have been cancelled.
Select the new wash cycle.
Loading the detergent
A successful wash also depends on the correct amount of
detergent being used, as recommended by the manufacturer.
Exceeding the recommended amount does not result in a
more effective wash and pollutes the environment.
Only use detergent which has been
specifically designed for dishwashers.
DO NOT USE washing up liquid.
The use of tablets is only recommended for
models which offer the MULTI-FUNCTIONAL
TABLETS option.
To obtain the best results from each washing and
drying cycle, powder detergent, rinse aid liquid and salt
should be used.
compartment A: Washing detergent
compartment B: Pre-wash detergent
1. Open cover C by pressing
button D.
2. Pour in the detergent after
consulting the
Wash cycle table
:
• for powder detergent use
compartments A and B
• for tablets, when the cycle
requires 1 tablet, place it in
compartment A and close the
cover; when it requires 2, place
the second tablet at the bottom of
the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
Washing options
Extra drying*
To make sure that the crockery is completely dry at the end of
the cycle, press the EXTRA DRYING button before selecting
the wash cycle. A prolonged beep will sound to indicate that
this option has been selected and a short beep will sound to
indicate when it has been deselected.
If the Extra drying option is selected, the wash cycles will
last longer.
