ARISTON DISHWASHER - Instructions for installation and use
15
D
ISHWASHER
You have loaded your dishes and you now have to set the
wash cycle. It takes just one minute to learn how
Starting the dishwasher
Ready, steady, go!
Selecting the wash
cycle.
To select the wash cycle, turn knob
"D" clockwise until the reference
notch on the knob corresponds with
the number or symbol for the cycle
you wish to set (have a look at the
wash cycle table on page 17).
After a few seconds, the wash
cycle has begun and we do not
recommend you change it.
The dishwasher keeps
you informed.
Your dishwasher is fitted with
indicator lights (G) which light up
to indicate the cycle phase under
way.
Here are the symbols correspond-
ing to each cycle phase:
pre-wash, wash, rinses, drying.
At all times, your dishwasher tells
you which cycle phase is under
way.
Modifying a wash cycle
in progress.
But if you have chosen the wrong
cycle, not to worry! You can modify
the wash cycle in progress, if it has
only just started. Turn the knob
anti-clockwise until it reaches the
Reset position and, after a few
seconds, the indicator light "G" will
turn off. This is to inform you that
all the settings have been can-
celled. You are now free to re-set
the correct wash cycle.
You've left out a dish?
Well, it happens to everyone.
Interrupt the wash cycle by
pressing the ON-OFF button, insert
the dish you had forgotten and
press the ON-OFF button again.
The cycle will start up from where
you interrupted it.
Finished?
The end of the wash cycle is
indicated by the flashing of the
drying phase indicator light.
Turn the knob anti-clockwise to
Reset in order to reset all the
settings.
Turn off the water tap.
Wait a few minutes before un-
loading the dishes: they are very
hot! If you wait a little while,
they dry better thanks to the
steam.
Empty the lower rack first.
There's been a power
failure? Have you
opened the dishwasher
door?
The wash cycle stops and then
restarts when the electricity
comes back on or when you
shut the door. Everything is
under control!
Warning:
Turn the appliance off by
pressing button A, unplug the
appliance from the electricity
socket to cut off the power
supply; the power supply cable
should consequently be easily
accessible.
First of all.
Turn on the water tap completely
and press ON-OFF button "A", and
indicator light "B" lights up. Now
the appliance is on and awaiting
instructions.
If opening the door
soon after the end
of the
programme,or
during it, stand
away from the
Dishwasher, to
avoid possible
injury from hot
steam.
Make sure the wash
cycle has ended
before removing the
dishes!
You can cancel the
wash cycle in
progress, if it has
only just started.
