26
Groundig instruction
This appliance must be earthed. In the event of a malfunction or breakdown, earthing will reduce the risk
of electric shock by providing a path of least resistance for the electric current.
This appliance is equipped with a cord having an equipment-earthing conductor and an earthing plug. The
plug must be plugged into an appropriate outlet that is installed and earthed in accordance with all local
standards and requirements.
Improper connection of the equipmentgrounding conductor can result in the risk of an electric
shock. Check with a qualified electrician or service representative if you are in doubt whether
the appliance is properly grounded. Do not modify the plug provided with the appliance; If it is
not fit for the outlet.
Have a proper outlet installed by a qualified electrician.
Please close the hydrant after using.
How to Connect the safety supply hose
The appliance must be connected to the water mains using new hose-sets.
The old hode-sets should not be reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is
below the minimum consult our Service Department of advice.
1. Pull the safety supply hoses completely out from storage compartment
located oa rear of dishwasher.
2. Tighetr the screws of the safety supply hose to the faucet with thread
3/4 inch.
3. Turn water fully on before starting the disheasher.
About the safety supply hose
The safety supply hose consists of the double walls. The hose’s system guarantees its intervention by
blocking the flow of water in case of the supply hose breaking and when the air space between the supply
hose itself and the outer corrugated hose is full of water.
A hose that attaches to a sink spray can burst if it is installed on the same water line as the
dishwasher. If your sink has one, it is recommended thet the hose be disconnected and the hole
plugged.
How to Disconnect the safety supply hose
1. Turn off the water.
2. Release the water pressure by depressing the pressure release button. This relieves water pressure
and protects you, and the room, from severe splashing.
3. Unscrew the safety supply hose from the faucet.
Cold water connection
Connect the cold water supply hose to a threaded 3/4 (inch) connectos and make sure that it is fastened
tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water run to
make sure that the water us clean and free of impurities. If this precaution is not taken, there is a risk that
the water inlet can get blocked and damage the appliance.
WARNING:
WARNING:
WARNING:
