12
Do not use the dishwasher if it has been
damaged in transit. Consult our After-Sales
Service or your local retailer.
(Refer to the separate assembly instructions
booklet)
Water inlet and drain:
•
Observe any special regulations issued by
your local Water Board.
•
Make sure the inlet and drain hoses are kink-
free and are not crushed.
•
If the hose length is not sufficient, please
contact your local dealer or our After-Sales
Service.
•
The inlet hose must be securely clamped to
the water tap to prevent leaks.
•
The water inlet pressure should not be less
than 0.3 bars.
•
If the water inlet pressure is higher than
10 bars, a pressure reducing valve should be
fitted between the appliance inlet and the
water source.
•
The inlet water temperature varies according
to the model installed: inlet hose marked “25° C
Max”: maximum temperature 25° C.
All other models: maximum temperature 60° C.
•
When installing the appliance, make sure the
drain water discharges correctly (if
necessary, remove the wire gauze from
the sink siphon).
•
Fix the drain hose to the siphon with a clamp
to prevent it from coming off during operation.
•
For appliances with water-stop system only:
If the water connections are made correctly
according to the instructions, the water-stop
system safeguards your home against
damage caused by flooding.
Electrical connection:
•
Observe the current regulations issued by
your local electricity supplier.
•
Voltage information is shown on the rating
plate mounted inside the door on the right
hand side.
•
The appliance must be earthed as prescribed
by law.
•
Do not use extension leads or multiple
adapters.
•
Before carrying out maintenance, disconnect
the mains plug.
•
The power cable must only be replaced by a
qualified technician.
•
The manufacturer cannot be held
responsible for damage caused by incorrect
earthing of the appliance.
• For Austria:
if the appliance is series
connected to a fault current switch, this must
be sensitive to the pulsating current.
CONNECTIONS
