Operating Instructions
Continued
Option selector buttons ;
Cycle control knob
4
Starting your dishwasher
1. Push a Cycle Selector Button for the desired
cycle. Normal Wash and Light Wash Cycles
share the same button. The Cycle Control Knob
determines which cycle operates.
2. Push an Option Selector Button for each
desired option. (Use AIR DRY for Rinse 8 Hold
Cycle.) The indicators above the buttons will
show which cycle and option(s) have been
selected.
3. Turn Cycle Control Knob clockwise to point to a
desired cycle. Heavy Wash and Pots 8 Pans
Cycles share the same spot on the dial. China
Crystal and Light Wash Cycles also share a
spot on the dial. The Cycle Selector Buttons
determine which cycle operates.
You will feel a definite stop at each cycle
mark. The dishwasher WIII automatically start
that cycle.
NOTE: If the door is latched. you will hear cycles
start and stop as the knob passes each cycle
mark. This is normal and will not hurt the dish-
washer. If you prefer, you can set cycles with the
door unlatched.
To add a dish after starting
1. To be sure the added item is washed and
rinsed, make sure the Cycle Control Knob has
not passed LIGHT WASH.
2. Lift up on the door latch to unlatch door and
stop the cycle. Don’t open the door until the
spray arms stop spinning.
3. Open the door and add the dish.
4. Close the door. Do not latch it. Wait 30 sec-
onds for air in the dishwasher to warm up. This
helps reduce the amount of moisture that can
come from the vent when restarting the cycle.
5. Press door in to latch it. The dishwasher will
start where it stopped.
Changing a cycle setting
You can change a setting anytime during
any cycle.
1. LIH up on the door latch to unlatch the door and
stop the cycle. Do not open Ihe door unlrl the
spray arms stop splnnlng.
