Guided Tour - AF1 / AG1 Transmitters
14
3: 15 dB Pad - Move this switch in the direction of the arrow to
reduce the output of the AF1 or AG1 by 15 dB when your
instrument is putting out too hot a signal. See the “Setting Up and
Using the AirLine System” section on page 15 in this manual.
4: Power switch - Move this switch in the direction of the arrow
to turn power to the AF1 or AG1 on; move it away from the arrow
to turn power off.
5: Antenna - This permanently attached flexible antenna should
be fully extended during normal operations. See the “Setting Up
and Using the AirLine System” section on page 15 in this manual
for more information about antenna positioning.
6: Battery cover - Pull back gently on this cover at the ribbing
and pry upwards to remove. See the “Setting Up and Using the
AirLine System” section on page 15 in this manual.
7: Battery compartment - Insert a standard AAA alkaline battery
here, being sure to observe the plus and minus polarity markings
shown. We recommend the Duracell type battery. Although
rechargeable Ni-Cad batteries can be used, they do not supply
adequate current for more than four hours. WARNING: Do not
insert the battery backwards; doing so can cause severe damage
to the AF1 / AG1 and will void your warranty.
