3
2. Plug the phone connector, located on the end of the coiled
cord, into the slot on the base of the phone. TOP should
face the same direction as the keypad. The connector will
only fit one way; do not force it.
3. Plug the microphone into the MIC jack located on the side
of the speakerphone.
Note: Replacement microphones (RSU 12294229) are
available through your local RadioShack store.
4. You can attach the microphone to either your car’s visor
or your clothing.
To use the supplied visor clip to attach the microphone to
the visor, tuck the wire into the space between the wind-
shield glass and trim, or under the trim, whichever is eas-
ier. Run the wire down to the dash and around the dash
edge, being careful not to put the wire where it can be
pinched by the door. Plug the microphone’s plug into the
side of the speakerphone. Make sure the microphone is
pointed toward you.
To use the small supplied lapel clip to attach the micro-
phone to your clothing, attach the clip about 6 inches
below your chin. Leave a comfortable length of cord
between the microphone and the speaker. Wrap up the
excess cord so it does not interfere with vehicle operation.
Note: To avoid feedback, position the microphone so it is
not directly in line with the speaker. You might need to
turn the speaker slightly.
