21
Step 7 Finish the Installation
1. Press on the release handle to lower the scanner
shelf.
2. Insert the main power cord into the power strip,
then connect it to a suitable 120-volt grounded
outlet.
Step 8 Connect to the
Network
1. Remove the plug from the Ethernet port on the
printer.
2. Install the ferrite core supplied in the printer box
on a suitable Ethernet network cable:
a. Loop the cable if necessary to keep the
ferrite core in place.
b. Place the open core about 1 inch from the
cable connector on the printer end.
c. Press the two halves of the core together
until they click shut.
TO PREVENT ANY POSSIBLE CRUSHING OF
FINGERS, KEEP YOUR HANDS AWAY FROM
THE POSTS AT THE BACK OF THE SCANNER
STAND WHEN MOVING THE SCANNER
SHELF DOWN
.
ES3640e MFP 85b.jpg
ES3640e MFP
90a.jpg
ES3640e MFP 03d.jpg
ES3640e MFP
58.jpg
NOTES
The Ethernet cable is not supplied with the
system.
In addition to the Ethernet port, the printer also
has a USB and a parallel port.
Important
This safeguard is an FCC requirement.
In order to reduce electromagnetic interference—
”noise” that interferes with TVs or other
appliances—you must place the enclosed ferrite
core on the network cable.
ES3640e MFP
68.jpg
