24 6 Printing From UNIX
Set Up Procedure
The setting procedure is as follows:
1. Setting up the printer
Set the IP address on the printer control panel.
Use the printer control panel or OkiWebRemote to set the LPD port to [Enable] (default:
[Enable]).
When necessary, set the following items using the printer control panel:
• Print Mode (default: [Auto])
• PJL (default: [Enable])
• Buffer Size (default: [Off])
Note
• Before activating the LPD port, set the IP address of the printer.
For details on how to set the IP address and the port, refer to the Setup Guide.
• OkiWebRemote allows more detailed settings.
2. Settings of the workstation
Set the printer in the workstation.
Refer to
• “6.2 Setting Up the Workstation” (P. 24)
6.2 Setting Up the Workstation
This section explains the settings of SunOS 4.1.4, HP-UX 11.0 workstation and Solaris 2.x
for printing.
Before Setup
Before setting up the workstation, check the following:
• The setup procedures and commands may vary according to different versions of OS.
Refer to the manuals that came with the workstation for details.
• To setup the printer, the user must be a superuser. Contact your network administrator
to perform the setup if you do not have the authority of a superuser.
• Check the IP address set up for the printer in advance. Be cautious as an incorrect IP
address may cause severe errors.
• Before performing any network setup (such as the IP address) to a host running under
NIS (Network Information Service), consult the NIS administrator.
Print Language/Mode
When setting the printer in a workstation, a printer name should be specified on the remote
host (printer).
The printer name depends on the print language/mode used for printing. The relationship
between printer name and print language/mode is as follows:
Printer name Print language/mode
PS PostScript
PSASC/PSA PostScript
