5.
Open the porthole. Remove the poly-
styrene block fitted on the door seal.
Remove from the drum the objects
supplied with the machine.
6.
Fill the smaller upper hole and the two
large ones with the corresponding plas-
tic plug caps supplied in the bag con-
taining the instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or other kitchen units. Level
the washing machine by raising or lowering
the feet. The feet may be tight to adjust as
they incorporate a self locking nut, but the
machine MUST be level and stable. If nec-
essary, check the setting with a spirit level.
Any necessary adjustment can be made
with a spanner. Accurate levelling prevents
vibration, noise and displacement of the
machine during operation.
Caution! Never place cardboard,
wood or similar materials under the
machine to compensate for any
unevenness in the floor.
Water inlet
An inlet hose is supplied and can been
found inside the machine drum. Do not use
the hose from your previous machine to
connect to the water supply.
This appliance must be connected
to a cold water supply.
1.
Connect the hose with the angled con-
nection to the machine.
2. Do not place the inlet hose downwards.
Angle the hose to the left or right de-
pending on the position of your water
tap.
3.
Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4.
Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
45°
35°
24
