6
Burley Bee Owner’s Instruction and Safety Manual
Installation and Use of the Cover
Your Big Screen 2-in-1 Cover is held in place by two snaps at the top of the frame,
four rubber o-rings (two in the front and two in the rear) as well as a fore and aft strip
of Velcro. Always use your cover to keep debris out (and toys inside) of the trailer
when it’s in use.
Installing the Cover
To install the cover, unfold it and snap the top
two snaps fi rst. Next, pull the cover toward the
back of the trailer and atach the rubber O-rings
and Velcro. Finish installation by attaching the
two front O-rings and Velcro.
Folding and Stowing the Front Window
Folding and stowing the front window is
quick and easy. Begin by unhooking the
window where it attaches to the O-rings
at the front of the trailer. Next, roll the
window up toward the top of the trailer.
Hold the window in place by inserting it
into the elastic loops at the top.
Tongue Installation and Operation
Install Tongue
To fa cil i tate tongue in stal la tion, tip your Bur ley Bee frame onto its back end. If you
are working on a rough or dirty sur face, lay down a cloth or other protective barrier.
Installing your Burley Bee tongue involves four simple steps (illustrated on page 7):
1. Slide the tongue onto the piv ot pin at the left front.
2. Remove the hairpin cotter and lock pin from the front tongue re cep ta cle, rotate
the tongue up into place, and snap it into the two plastic tongue re cep ta cles.
3. Secure the tongue by push ing the lock pin fully into the front tongue re cep ta cle.
4. Rotate the lock pin and lo cate the hole in it which will be between the re cep -
ta cle and the trailer frame. Anchor the lock pin by inserting the hair pin cotter all
the way into the hole in the lock pin.
