HEATERS
- Heater Control
24-11
Top view
Bottom view
I
2OW553
2OW534
\
2OW750
SERVICE POINTS OF INSTALLATION
N24GDAD
11. APPLICATION OF GREASE TO HEATER CONTROL AS-
SEMBLY
Apply the chassis grease to all the moving parts of the
heater control assembly.
10. lNSTALLATlON OF WATER VALVE CONTROL WIRE
Connect the water valve control wire to the water valve
control lever by following the steps below.
(1) Move the temperature control lever to the extreme left
position
(2) With the water-valve control lever pressed inward in
the direction indicated by the arrow, connect the inner
cable of the water-valve control wire to the end of the
water-valve control lever, and then secure the outer
cable by using a clip.
9. INSTALLATION OF MODE SELECTION CONTROL WIRE
Connect the mode selection control wire to the mode
selection damper lever by following the steps below.
(1) Move the mode selection lever to the %E position.
(2) With the mode selection damper lever pressed inward
in the direction indicatecl by the arrow, connect the
inner cable of the mode selection control wire to the
end of the mode selection lever, and then secure the
outer cable by using a clip.
2. INSTALLATION OF AIR SELECTION CONTROL WIRE
Connect the air selection control wire to the air selection
damper lever by following the steps below.
(1) Move the air selection control lever to the& position.
(2) With the air selection damper lever pressed inward in
the direction indicated by the arrow, connect the inner
cable of the air selection control wire to the end of the
air selection lever, and then secure the outer cable by
using a clip.
1 STB Revision
