Page 22

AFL2-W15B-H61

 Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,

to configure the jumpers or plug in added peripheral devices, ground

themselves first and wear and anti-static wristband.

3.3 Installation and Configuration Steps

The following installation steps must be followed.

Step 1: Unpack the flat bezel panel PC.

Step 2: Install the HDD.

Step 3: Install the CF card.

Step 4: Install the RFID reader. (optional)

Step 5: Configure the system.

Step 6: Connect peripheral devices to the flat bezel panel PC.

Step 7: Mount the flat bezel panel PC. Step 0:

3.4 HDD Installation

WARNING:

Over-tightening back cover screws will crack the plastic frame.

Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).

To install the HDD into the AFL2-W15B-H61, please follow the steps below:

Step 1: Remove two (2) retention screws from the HDD cover (

Figure 3-1).