Step 4: Secure the DVD-ROM to the DVD-ROM bracket using four screws (two screws
on each side) (Figure 5-11).
Figure 5-11: DVD-ROM Bracket Screws
Step 5: Install the new DVD-ROM cover and fasten four screws on the DVD-ROM cover.
The new DVD-ROM cover can be found in the packing list and is shown in
Figure 5-12.
Figure 5-12: DVD-ROM Cover
5.8 AT/ATX Mode Selection
AT or ATX power mode can be used on the AFL2-17A/AB-H61. The selection is made
through an AT/ATX switch located on the bottom panel (Figure 5-13). To select AT mode
or ATX mode, follow the steps below.
Step 1: Locate the AT/ATX switch on the bottom panel (Figure 5-13).
