Dil ID: 7
Dil Adı: french
Dil Kodu: fr1tayfun Produits de la Marque Hotpoint
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



6
GB
Ensure the drain hose is securely
attached, to prevent it coming away
while the machine is in use and
causing a flood.
Fit hose to waste securely using
a “Jubilee” type clip.
Anti-flooding protection*
To ensure floods do not occur, the dishwasher:
- is provided with a special system which blocks the water supply
in the event of anomalies or leaks from inside the appliance.
Some models are also equipped with the supplementary safety
device New Acqua Stop*, which guarantees anti-flooding
protection even in the event of a supply hose rupture.
WARNING: HAZARDOUS VOLTAGE!
Undernocircumstanceshouldthewaterinlethosebecutasit
contains live electrical parts.
TheCompanyshallnotbeheldresponsibleforanyincidents
that occur if these regulations are not observed
Switching the appliance on for the first time
Advice regarding the first wash cycle
After the appliance has been installed, immediately before
running the first wash cycle, completely fill the salt dispenser
withwaterandaddonlythenapproximately1kgofsalt(
see
chapterRinse-aid and refinedsalt
). The water may overflow:
this is normal and is not a cause for concern. Select the water
hardness value (
seechapterRinse-aidandrefinedsalt
). After the
salthasbeenpouredintothemachine,theLOWSALTindicator
light * switches off.
If the salt dispenser is not filled, the water softener and the
heating element may get damaged as a result.
The machine has a buzzer/set of tones
(depending on the
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
light
(depending on the dishwasher model)
.
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
Transportation
Unloadallcrockeryfromthedishwasherandsecuremoving
parts.
All water remaining inside the appliance should be drained
as follows:
makesurethatthewatertapisopenandselecttheECOcycle.
The cycle will begin. After 5 minutes, end the cycle by pressing
theON/OFFbuttonuntilyouhearabeepandtheindicatorlights
switchoff.Waitforapproximately5minutesbeforeuninstalling
the appliance. Shut off the tap and disconnect the inlet and
drain hose.
The appliance should only be moved in an upright position, in
order to prevent any water remaining inside the appliance from
damaging dishwasher components.
Leaving the machine unused for extended periods/
Freezing protection
If the appliance is situated in a location which is at risk of
freezing, or if you intend to be away for extended periods of time
(e.g. holiday home)
, empty the appliance completely.
-Carryouttheprocessusedtodrainallwaterremaininginside
the appliance
(see Transportation).
-Disconnecttheappliancefromtheelectricitysupplyandshut
off the water tap.
- Leave the appliance door ajar.
-Whenyoureturn,runacyclewhilethedishwasherisempty.