Produits de la Marque Hotpoint

Troubleshooting

Whenevertheappliancefailstoworkproperly,checkforasolutionfromthefollowinglistbeforecallingforAssistance

Problem: Possible causes / Solutions:

The dishwasher does not start or cannot

be controlled.

• SwitchofftheappliancebypressingtheON/OFFbutton,switchitbackon

after approximately one minute and reset the cycle.

• Theappliancehasnotbeenpluggedinproperly.

• Thedishwasherdoorhasnotbeenshutproperly.

The door won’t close.

• Thelockwasreleased.Stronglypushthedooruntila“clacking”noiseis

heard.

No water drains from the

dishwasher.

• Thedishwashercyclehasnotyetfinished.

• Thewaterinlethoseisbent(see Installation).

• Thedrainductisblocked.

• Thefilteriscloggedupwithfoodresidues.

The dishwasher makes excessive

noise.

• Thedishesarerattlingagainsteachotheroragainstthesprayerarms.

• Anexcessiveamountoffoamhasbeenproduced:thedetergenthasnot

been measured out correctly or it is not suitable for use in dishwashers

(see Start-up and use).

The dishes and glasses are

covered in a white film or

limescale deposits.

• Thelevelofrefinedsaltisloworthedosagesettingisnotsuitedtothe

hardness of the water (see Rinse aid and salt).

• Thelidonthesaltdispenserisnotclosedproperly.

• Therinseaidhasbeenuseduporthedosageistoolow.

The dishes and glasses are

streaked or have a bluish tinge.

• Therinseaiddosageistoohigh.

The crockery has not been dried

properly.

• Awashcyclewithoutadryingcyclehasbeenselected.

• Therinseaidhasbeenuseduporthedosageistoolow(see Rinse aid

and salt).

• Therinseaiddispensersettingisnotsuitable.

• Thecrockeryismadefromnon-stickmaterialorplastic.

The dishes are not clean. • Theracksareoverloaded(see Loading the racks).

• Thecrockeryhasnotbeenarrangedproperly.

• Thesprayerarmscannotrotatefreely.

• Thewashcycleistoogentle(see Wash cycles).

• Anexcessiveamountoffoamhasbeenproduced:thedetergenthasnot

been measured out correctly or it is not suitable for use in dishwashers

(see Start-Up and Use).

• Thelidontherinseaidcompartmenthasnotbeenshutcorrectly.

• Thefilterisdirtyorblocked(see Care and maintenance).

• Therefinedsaltlevelislow(see Rinse aid and salt).

• SwitchofftheappliancebypressingtheON/OFFbutton.Shutoffthe

water tap to eliminate the risk of flooding and remove the plug from the

electrical socket.

Make sure the water inlet filter has not become blocked by impurities (see

“Careandmaintenance”chapter).

The dishwasher does not take any

water in - Tap shut-off alarm

(indicatorlightON/OFFashing;H2O and

tap symboldisplayed;F 6 appears after a

few seconds).

• Thereisnowaterinthemainssupply.

• Thewaterinlethoseisbent(seeInstallation).

• Turnonthetapandtheappliancewillstartafterafewminutes.

• Theappliancelockhasbeenactivatedbecausenoactionwastakenwhen

the beeps sounded.

Switch off the appliance using the ON/OFF button, turn on the tap and

switch the appliance back on after a few seconds by pressing the same

button. Re-program the appliance and restart the wash cycle.

Clogged lter alarm

The“lter”symbolonthedisplaywilllight

up.

• Makesurethewashcyclehasended,openthedishwasherdoorand

cleanthecupfilterandstainless-steelfilter(see“Careandmaintenance”

chapter).The“blockedfilter”symbolwillgooffwhenthefollowingcycle

starts.

*Onlyavailableinselectedmodels.