INSTALLATION
¥
NOTE: Install this telephone away from electronic
equipment, such as personal computers, television sets
or microwave ovens. Avoid excessive heat, cold, dust
or moisture.
1 Connect the telephone line cord. (figure a)
2 Connect the power cord to the base and an electrical outlet
not controlled by a wall switch. (figure a) The ANSWER
ON/OFF light goes on, and CL flashes in the message window.
Use only the power cord supplied with this product.
If you need a replacement, call 1 800 222–3111.
3 Install the handset battery. Use only AT&T Battery 2401,
SKU# 91077. (figure b)
4 Charge the handset battery.
• Place the handset in the base.
• Charge the battery at least 12 hours. After the first charge,
the battery will charge in eight hours.
5 Check for dial tone.
• After the batteries are charged, lift the handset and press
P; you should hear a dial tone.
For detailed installation instructions, to use the belt clip, or to
use a headset with this phone please refer to the INSTALLATION
section of your User’s Manual.
FEATURE SETUP
Dial Mode (Tone/Pulse)
This phone comes set for touch tone dialing. If you have dial pulse
(rotary) service, you must set the dial mode to PULSE.
1 Make sure the handset is off.
2 Press ***on the base. You will hear a tone and the LINE
IN USE light will flash.
3 Press 0. If the IN USE light goes on, you have selected TONE.
If the light goes off, you have selected PULSE. Press
0 again
to change your selection.
4 Press # to save your selection
— OR —
Press * to exit without saving.
Set Time
You can choose to set the time manually, or you can allow it to be
set automatically with incoming Caller ID information.
1 Press on the handset.
2 Press until the screen displays
3 Press . The screen displays the current time setting.
Use to move the cursor, and use the keypad to
change a digit. Select .
4 Press to save the displayed time.
SAVE
AM/PM
OK
CALLS LOG
INTERCOM
HANDSET SETTINGS
SET TIME
MENU
QUICK START GUIDE
5.8 GHz Cordless Telephone 5830
with Talking Caller ID/Call Waiting
b) Align the
contacts and
place the battery
pack in the
battery
compartment
a) Remove battery
compartment
cover by pressing
on the raised
spot and sliding
downward.
Modular
telephone
jack
Standard
electrical
outlet
Power cord
Line cord
figure a
figure b
Draft
8/14/02a
c) Replace cover
by sliding it on
its track up over
battery case until
it snaps firmly
into place.
SET TIME
▲
OK
▼
