Back to Contents Page
Adding and Replacing Parts
Dell™Dimension™2200
Safety Instructions
As you use your computer, observe the following safe-handling guidelines. For comfort and efficiency, observe the ergonomic guidelines provided in "Sitting
Comfortably at Your Computer" in the Tell Me How help file.
When Using Your Computer
l Your computer is equipped with either an auto-sensing voltage selector or a manual voltage-selection switch. Computers with an auto-sensing voltage
selector do not have a voltage-selection switch on the back panel and automatically detect the correct operating voltage. Computers with a voltage-
selection switch on the back panel must be manually set to operate at the correct operating voltage. To help avoid damaging a computer with a manual
voltage-selection switch, be sure that the voltage-selection switch is set to match the AC power available at your location:
¡ 115 V/60 Hz in most of North and South America and some Far Eastern countries such as South Korea and Taiwan
¡ 100 V/50 Hz in eastern Japan and 100 V/60 Hz in western Japan
¡ 230 V/50 Hz in most of Europe, the Middle East, and the Far East
Also be sure that your monitor and attached devices are electrically rated to operate with the AC power available in your location.
l To help prevent damage to your computer when disconnecting a network cable from your computer, first unplug the cable from the computer network
connector and then from the network wall jack. When reconnecting a network cable to your computer, first plug the network cable into the network wall
jack and then into the computer network connector.
l To help avoid possible damage to the system board, wait 5 seconds after turning off the computer before disconnecting or connecting a non-USB device.
l To help prevent electric shock, plug the computer and device power cables into properly grounded power sources. These cables are equipped with 3-
prong plugs to help ensure proper grounding. Do not use adapter plugs or remove the grounding prong from a cable. If you must use an extension
cable, use a 3-wire cable with properly grounded plugs.
l To help protect your computer from sudden, transient increases and decreases in electrical power, use a surge suppressor, line conditioner, or
uninterruptable power supply.
l Be sure that nothing rests on your computer cables and that the cables are not located where they can be stepped on or tripped over.
l Do not spill food or liquids on your computer. If the computer gets wet, contact Dell.
l Do not push any objects into the openings of your computer. Doing so can cause fire or electric shock by shorting out interior components.
l Keep your computer away from radiators and heat sources. Also, do not block cooling vents. Avoid placing loose papers underneath your computer; do
not place your computer in a closed-in wall unit or on a bed, sofa, or rug.
When Working Inside Your Computer
Before you open the computer cover, perform the following steps in the sequence indicated.
Shutting Down the Computer
Power Supply and Fan Assembly
Removing the Computer Cover
Looking Inside Your Computer
Adding or Removing Cards
Rotating the Power Supply
3.5-Inch Front-Panel Insert
Replacing the Microprocessor
Replacing the System Board
Lower 3.5-Inch Floppy Drive
Replacing the Computer Cover
CAUTION: Do not operate your computer with any cover(s) (including the computer cover, filler brackets, front-panel inserts, and so on)
removed.
NOTE: The voltage selection switch must be set to the 115V position even though the AC supply in Japan is 100 V.
NOTICE: Do not attempt to service the computer yourself, except as explainedinthisguideandelsewhereinDell™documentation.Alwaysfollow
installation and service instructions closely.
