The following table shows System Security option information.
Clearing Forgotten Passwords
If you forget your system or setup password, you cannot operate your computer or change settings in the system setup program until you clear the forgotten
password(s).
1. Shut down the computer.
2. Turn off any attached devices and disconnect them from their electrical outlets.
3. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4. Remove the computer cover.
5. Locate jumper PSWD on the system board and remove the jumper plug.
6. Replace the computer cover, plug your computer into an electrical outlet, and turn on the computer.
The existing password(s) are erased.
7. Shut down the computer.
8. Turn off any attached devices and disconnect them from their electrical outlets.
9. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
10. Remove the computer cover.
11. Install the PSWD jumper plug.
12. Replace the computer cover, plug your computer into an electrical outlet, and turn on the computer.
Turning on your computer with the PSWD jumper installed reenables the password feature.
Back to Contents Page
Specifies how the computer will respond to boot integrity services authentication requests when no certificate has been installed. When
set to Deny (the default), this request is rejected. The request is accepted when set to Accept.
