Back to Contents Page
System Codes and Messages
Dell™Dimension™2200
Diagnostic Codes
POST Beep Codes
System Messages
Diagnostic Codes
Your computer is equipped with four diagnostic lights, which are labeled "A," "B," "C," and "D" on the back of the computer. Each of the four lights can be
yellow, green, or off as shown in the following table. When the computer is turned on or restarted and it is functioning normally, the lights flash during POST.
After the computer starts, the lights remain green to signify normal computer operation.
If a malfunction is detected and the computer fails to start, the lights display a code that identifies the problem. Write down the diagnostic code displayed and
look it up in the following table.
Make sure that the computer is connected to a known working electrical outlet, and then check
whether the front-panel power light on the power button is on or off. If the power light is off, check
the power supply. If the problem persists, see "Contacting Dell" in the Owner's Manual for instructions
on obtaining technical assistance.
See "Safety Instructions," and then remove all cards.Ifthecomputerstilldoesnotstart,see
"Contacting Dell" in the Owner's Manual for instructions on obtaining technical assistance.
System board is receiving
power, but the BIOS is not
executing.
Set the jumper PSWD to Maintenance mode, and restart the computer. Exit and save changes in the
system setup program. Turn off the computer and reset the configuration jumper to Normal mode, and
then restart the computer.
See "Safety Instructions," and then remove all cards and restart the computer to determine if a
resource conflict exists. If a conflict exists, see "Resolving Software and Hardware Incompatibilities." If
the problem persists, see "Contacting Dell" in the Owner's Manual for instructions on obtaining
technical assistance.
Recovery mode from BIOS
failure.
Set the jumper PSWD to Maintenance mode and restart the computer. Exit and save changes in the
system setup program. Turn off the computer and reset the configuration jumper to Normal mode, and
then restart the computer.
See "Safety Instructions," and then remove all cards and restart the computer to determine if a
resourceconflictexists.Ifaconflictexists,see"Resolving Software and Hardware Incompatibilities." If
the problem persists, see "Contacting Dell" in the Owner's Manual for instructions on obtaining
technical assistance.
Microprocessor has failed a
BIOS test.
If the problem persists, see "Contacting Dell" in the Owner's Manual for instructions on obtaining
technical assistance.
Memory failed to be sized or
enabled.
Reseat the memory modules.Iftheproblempersists,see"ContactingDell"intheOwner's Manual for
instructions on obtaining technical assistance.
No memory modules are
detected.
l Reseat all memory modules, and then restart the computer.
l To eliminate the possibility of a faulty memory connector, remove all memory modules, reinstall
one memory module (if the computer supports a single module), and then restart the computer.
If the computer starts normally, move the memory module to a different connector and restart
the computer. Continue until you have identified a faulty connector or reinstalled all modules
without error.
If the problem persists, see "Contacting Dell" in the Dell Owner's Manual for instructions on obtaining
technical assistance.
Memory modules are
detected, but a memory
configuration or compatibility
error exists.
l Be sure that there are no special memory module/memory connector placement requirements.
l Verify that the memory modules that you are installing are compatible with the computer.
If the problem persists, see "Contacting Dell" in the Dell Owner's Manual for instructions on obtaining
technical assistance.
PCI bus failure has occurred.
See "Safety Instructions," and then remove all cards and restart the computer to determine if a
resource conflict exists. If conflict exists, see Resolving Software and Hardware Incompatibilities If the
problem still persists, see "Contacting Dell" in the Owner's Manual for instructions on obtaining
technical assistance.
Video controller failed to
initialize or respond.
See "Contacting Dell" in the Owner's Manual for instructions on obtaining technical assistance.
