8
Conference Microphone DC10
9) More functions
Function indicator (LED)
The function indicator shows the unit's mode settings.
Music position
Flashes green once every three seconds.
Omni position – Wide
Flashes green twice every three seconds.
Omni position – Narrow
Flashes green three times every 3 seconds.
Zoom position
Flashes green four times every 3 seconds.
During charging the indicator shows red. When the
charging is completed, the indicator shows green.
The indicator stays red even when the battery is fully
charged, if the unit is On during charge.
When the battery level gets low, the indicator flashes
red. (Check the battery status on the display)
Once the unit has been set to receive pairing
information, the indicator flashes green quickly.
When receiving pairing information, the indicator shows
green for three seconds.
When sending pairing information, the indicator flashes
red five times.
When the pairing mode for Bluetooth has been
activated, the indicator shows blue.
When a Bluetooth telephone has been successfully
connected, the indicator flashes blue five times.
During an ongoing telephone call, the indicator flashes
blue every second second.
When Clear settings is selected, the indicator flashes
blue ten times.
Bluetooth
The Conference Microphone DC10 can be connected to
two Bluetooth telephones at the same time. The person
you are talking to can hear you through the microphones
on DC10. His/Her voice is sent to a paired Digisystem
receiver.
When Bluetooth is activated in the menu,
the Bluetooth symbol is shown in the display
If only one telephone has been paired (and connected)
with the unit, the figure 1 appears at the Bluetooth
symbol in the display. If two telephones have been
paired (and connected) the figure 2 appears instead.
Some DECT telephones are only connected during
incoming or outgoing calls. In such cases, the unit can
also display a 1, even if a mobile and a DECT telephone
have been paired with the unit.
The DC10 supports both headset and handsfree profiles
for Bluetooth. The profile is chosen automatically during
pairing.
Application
Pairing with telephones:
To pair the unit with telephones, see the section
Communication
.
Activate Bluetooth:
Enter the menu Communication - Bluetooth - Enable
Bluetooth menu:
When BT only is selected, the transmitter is active only
when the telephone call is connected via Bluetooth or a
headset cable is connected and activated.
Pair Mobile
(Communication - Bluetooth - Pair BT-
Pair Mobile) (code 1234) is used to pair a mobile with
the DC10.
Pair Phone
(Communication - Bluetooth - Pair BT- Pair
Phone) (code 0000) is used to pair a landline-based, wire-
less (DECT) or mobile phone with the DC10.
Select Clear settings (Communication - Bluetooth -
Pair BT- Clear settings) to clear all information about
paired units.
Please note: After this the Bluetooth units have to be
paired again (so that Bluetooth can work).
You can use Mix level to select how loud your own voice
is during a phone call.
Answer an incoming call:
Press the answering button briefly (around 1/2 second),
or answer with the telephone.
End a call:
Press the answering button briefly (around 1/2 second),
or end the call with the telephone.
Make a call:
When you make a call, the sound is automatically trans-
ferred via the relevant Bluetooth connection (depending
on the telephone's settings) to the DC10.
