30
Connecting to the mains water supply
• Fit the seal included in the hose packing at the end of the water
inlet hose on the tap side.
• Connect the water inlet hose to a 3”/4, geared water tap. Then
securely tighten the connecting nut by hand.
• After connections are completed, check for the non-leakage of the
connection joints by turning on your tap completely.
For your washing machine to work properly, the mains water
pressure must be between 0.05 and 1MPa (0.1 - 10 bar).
Drainage connection
• It is recommended that you have a
fixed drainage outlet 60 to 70 cm
from the floor.
• Avoid the drain hose being too tight,
kinked or restricted.
• The water outlet can either be
connected to a water drain or to
a sink outlet spigot. This connect
should be a minimum of 60cm and
a maximum of 100cm from the floor.
The drain hose should be no longer
than 4m in length to ensure good
performance from the washing
machine.
• After connecting the water supply,
check to ensure there are no leaks.
fig. 11
min
60 cm
