Authored by Simon Adams Product Support Specialist Canon UK RCC December 05
Revision 1.0 © Canon 2006
10
Stage 3 – Setting up the WFT-E1A using the WFT-E1A Utility
Load the utility from the Canon WFT-E1A disc.
In the first tab TCP/IP, select “Use the following IP address” and enter and IP address here which will
identify the WFT-E1A to the network. Ensure this address is not used by any other network device. We
have used 192.168.0.50 here. The subnet mask should be set to 255.255.255.0 as only the last set of
numbers will change on the network.
If we are using Ad Hoc (Peer to Peer) mode there is no gateway, so set this to 0.0.0.0. If you are using
a wireless router or access point then set the gateway to the IP address of the access point or router.
