4
2
1
1
1
2
Action
Action
Action
Note
<Default State>
Restoring the Printer's Default LAN Setting to Perform Setup Again
The LAN setting of the printer is now restored to the default state.
Use the RESUME/CANCEL button on the printer to restore the default state.
Hold down the RESUME/CANCEL
button (A) on the printer until
the POWER lamp (B) ashes 10
times, then release the RESUME/
CANCEL button after the tenth
ash.
Changing the Port Name
By changing the port name, you can change the name of the printer.
When you set up an additional computer to use the printer whose port name you changed, the
printer is displayed with the changed port name. When two or more computers are set up, the
changed name is displayed.
When multiple computers or printers are present, this can be used to change the name to one that
is easy to remember.
•
The port name can be changed by the following procedure.
Change the port name.
Port names should consist of alphanumeric characters and be no longer than 21 characters,
excluding the prex.
•
The port name includes the xed prex "CNBJNP_", which you do not need to enter.•
Click Set Port Name in the Setup Completion
dialog box.
The Set Port Name dialog box is displayed.•
Perform setup again by following the procedures in "Wired LAN Connection" (Windows: P.23,
Macintosh: P.32) and onward in the printed manual: Getting Started.
•
Printing the Printer's Network Setting Information
Use the RESUME/CANCEL button on the printer to print the network setting information.
Hold down the RESUME/CANCEL
button (A) on the printer until
the POWER lamp (B) ashes 6
times, then release the RESUME/
CANCEL button after the sixth
ash.
TCP/IP setting Obtain an IP address automatically
Disconnect the LAN cable.
Printing will start.
