Witheachwashcycle.
Compartment
For programmes with pre-wash only.
(Follow the user instructions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models w ith water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Close the door, t urn on the water tap. The machine will start working after about 1 0 seconds.
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower b asket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. S often r emnants of burnt foo d in pans,
then load the baskets. Refer to the dishwasher loadin g instruct ions.
Press the Programm e button until the selected programme lights up.
( See the section entitled Oper ation instruction )“”
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON /OFF button.
If the appliance is switched
off during a wash cycle.
Op en t he do or c areful l y.
Hot st eam may esc ape
when thedoor is opened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-s elect th e washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Press the On/Off button to switch on the appliance, Open the door.
1.Open the doo r a little to st o p the dishwasher.
2.After the spray arms stop working, you can open the d oor completely.
3.Add the forgotten dishes.
4.Close the do or, the dishwasher will start running again after 10 seconds.
For detailed operating method read the co rresponding content on the instruction manual.
1. A running cycle can o nly be modified if it has been running for a short time. Otherwise the detergent
m ay have already been released and the water a lready drained. If this is the case, the detergent
dispenser must be refilled.
2. Open the door a little to stop the washing, then press the Program button for more than 3 seconds to
c ancel the running program me.
3. Select a new programme, then close the door. The machine will restart after about 10 s econds.
