AL; Reviewed:
SPOC 8/24/2006
Solution & Interoperability Test Lab Application Notes
©2006 Avaya Inc. All Rights Reserved.
4 of 23
JNPR-M7i-J4300
3. Equipment and Software Validated
The following equipment and software/firmware were used for the sample configuration provided:
Equipment Software/Firmware
Avaya S8300 Media Server with G350
Media Gateway
Avaya Communication Manager R3.1
(R03.1-01.0.628.6)
Avaya S8500 Media Server Avaya Communication Manager R3.1
(R03.1-01.0.628.6)
Avaya G650 Media Gateway -
TN2312BP IPSI HW03 FW009
TN799DP C-LAN HW01 FW015
TN2302AP IP MedPro HW18 FW108
Avaya 4602SW IP Telephone (H.323) R2.3 – Application (a02d01b2_3.bin)
Avaya 4610SW IP Telephone (H.323) R2.3 – Application (a10d01b2_3.bin)
Avaya 4620SW IP Telephone (H.323) R.2.3 – Application (a20d01b2_3.bin)
Avaya IP Softphone R5.24.8
Juniper Networks M7i router JUNOS 7.6R2.6
Juniper Networks J4300 router JUNOS 7.6R2.6
4. Configure Juniper Networks Routers
This section describes the configuration for Juniper Networks J4300 and M7i routers shown in
Figure 1.
4.1. Configure the Juniper Networks J4300 router
This section shows the necessary steps in configuring the J4300 router as shown in the network
configuration in Figure 1. The following steps use the Command Line Interface (CLI) offered by
the J4300 router.
Step Description
1.
Connect to the J4300. Log in using the appropriate Login ID and Password.
login:
Password:
A prompt similar to the following will appear after successful log in.
interop@J4300>
2.
Enter configuration mode by typing in edit at the prompt.
interop@J4300> edit
interop@J4300#
