Operating Instructions
25
Interrupting the Wash Programme
(only in emergencies)
3
Interrupt a wash programme in progress only when it is absolutely
necessary to do so. When the appliance is closed again, the air that
has entered the appliance is heated and expands significantly. As result
water may penetrate into the base of the appliance and trigger the leak
prevention system.
1
Hot steam may escape from the appliance when opening the door.
Open the door carefully.
0 1. Open the door of the dishwasher.
2. Rectify the reason for opening the appliance.
3. Close the door. The selected programme will then continue.
Setting or Changing the Delay Start Timer
Using the delay start timer you can delay.
0 1. Press the ON/OFF button.
2. Press the button for the desired wash programme.
3. Setting the delay start:
Press the DELAY TIMER button until the indicator next to the number of
hours of delay illuminates.
Changing the start delay:
As long as the wash programme has not started, you can still change
the delay start set by pressing the DELAY TIMER button.
3
If a delay start is selected, the programme progress display does not
illuminate.
4. Close the door.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower rack, an intelligent electronic system adjusts
the amount of water and the duration of the wash programme to the
number of dishes. By this means it is possible to wash only a few dishes
quickly and economically. At half load (6 place settings), up to 2 litres
of water and 0.2 kWh of electricity are saved.
