Selecting the delayed start.
• Select the programme and the required options.
• Select the delay start.
• Press button 7: the appliance starts its hourly countdown. The programme will start after
the selected delay has expired.
Cancelling the delayed start
• Set the washing machine to PAUSE by pressing the button 7;
• Press button 8until the symbol
’ is displayed;
• Press the button 7 again to start the programme.
The selected delay can be changed only after selecting the washing programme again.
The Delay Start can not be selected with Drain programme.
Altering an option or a running programme
It is possible to change some options before the programme carries them out. Before you
make any change, you must pause the washing machine by pressing the button 7.
Changing a running programme is possible only by resetting it. Turn the programme se-
lector dial to
and then to the new programme position. Start the new programme by
pressing the 7 button again. The washing water in the tub will not emptied out.
Interrupting a programme
Press the button 7 to interrupt a programme which is running, the corresponding light
starts blinking. Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to to cancel a programme which is running. Now you can select a
new programme.
Opening the door after the programme has started
When the machine is working and throughout the delay time the door is locked. If, for any
reason, you wish to open the door, set firstly the machine to pause by pressing the button
7.
• If the DOOR symbol blinks and after a few minutes disappears, the door can be opened;
• If the DOOR symbol doesn't go off, it means that the machine is already heating or that
the water level is too high. In this case the door cannot be opened;
• If you cannot open the door but you need to open it, you have to switch the machine off
by turning the selector dial to
. After a few minutes the door can be opened (pay
attention to the water level and temperature!);
After closing the door, it is necessary to select the programme again and to press button 7.
At the end of the programme
The machine stops automatically, the light of button 7 goes off. A blinking appears on
the display and the acoustic signal sounds for some minutes.
If you have chosen a programme or an option that ends with water in the tub, follow the
below instruction to empty the water out. The drum continues to run at regular intervals
until the water draining.
Daily use
13
