40
I
nstruction book
Filling the rinse aid
Use of rinse aid will result in cleaner and faster drying of the load, since it
helps water and soil to run off. Too much rinse aid may result in streakiness,
too little may cause white spots.
Caution!
Only use rinse aid specifically designed for domestic dishwashers. Never fill
the rinse aid dispenser with any other substance (e.g. vinegar concentrate
or dishwasher detergent) as this would damage the appliance.
The rinse aid dispenser is on the inside of the dishwasher door.
1. Open the lid to the dispenser by
pressing the lid catch towards the
compartment and lift the lid.
2. Fill up with rinse aid; do not overfill.
Maximum inhold ca. 150 ml.
3. Wipe off any spillage carefully to
prevent excessive foaming during
the next wash programme.
4. Close the lid and press until it locks
again.
Fill with rinse aid:
When the indicator light on the control panel is lit.
Adjusting rinse aid dosing
The dispenser holds about 150 ml. This is enough for approx. 60 wash
cycles, depending on the dosage setting. Adjust the dosage setting
according to the hardness of the water.
You can set the dosage between 1 - 6, equivalent to 1 - 6 ml rinse aid.
Factory setting is 1. Begin at the lowest dosage setting and increase if
necessary by turning the setting arrow with e.g. the handle of a spoon.
