What to do if…30
Malfunction Possible cause Remedy
The cycle indicator for the se
lected dishwashing cycle is
flashing:
fault code Å10 is displayed
in the multidisplay:
(Problems with water inlet)
Water tap is blocked with
limescale or faulty.
Check the water tap and have it
repaired if necessary.
The tap is turned off. Turn the tap on.
The filter (where present) in the
threaded hose fitting on the
tap is blocked.
Clean the filter in the threaded
hose fitting.
Filters in the base of the dish
washer compartment are
blocked.
Cancel the dishwashing cycle
(see chapter: Starting a dish
washing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing cy
cle again.
Water inlet hose
has not been correctly posi
tioned.
Check the position of the hose.
The cycle indicator for the se
lected dishwashing cycle is
flashing,
fault code
Å20 is displayed
in the multidisplay.
(Problems with water drain
age)
The sink outlet is blocked. Clean out sink outlet.
Water drain hose
has not been correctly posi
tioned.
Check the position of the hose.
Fault code Å30 is displayed
in the multidisplay.
The antiflood system has been
triggered.
First shut off the water tap,
then switch off the appliance
and contact the Customer Care
Department.
The cycle is not starting.
The mains plug is not
plugged in.
Plug in mains plug.
A fuse in the house’s wiring
system is defective.
Replace fuse.
For dishwasher models with a
delay start timer:
A start time has been selected.
If the dishes are to be washed
immediately, cancel the delay
start.
