Prior to using for the first time8
2. Press function buttons 2 and 3 simultaneously and keep them pressed.
The LED indicators for function buttons 1 to 3 will flash.
3. Press function button 1.
The LED indicator for function button 1 will flash.
The LED indicator for the end of the dishwashing cycle will flash simultaneously:
– The number of times that the LED indicator for the end of the dishwashing cy
cle flashes corresponds to the hardness setting.
– This sequence of flashes is repeated several times, with a 3 second pause in
between.
4. Pressing function button 1 increases the hardness setting by 1 degree.
(Exception: hardness setting 1 follows hardness setting 10).
5. When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to “1”, this switches off the control in
dicator for special salt.
Water hardness
Setting for
water hardness
Number of
flashes
Number of
acoustic
signals
1)
1) The water hardness will only be indicated acoustically if the acoustic signal has been activated.
in
°d
2)
2) (°d) German degree, measure of the hardness of water
in
mmol/l
3)
3) [mmol/l] millimol per litre, international unit for water hardness
Range Manual Electronic
51 70
43 50
37 42
29 36
23 28
9,0 12,5
7,6 8,9
6,5 7,5
5,1 6,4
4,0 5,0
IV
2*
10
4)
9
8
7
6
4) On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
10
9
8
7
6
10
9
8
7
6
19 22
15 18
3,3 3,9
2,6 3,2
III
5*
4
5
4
5
4
1
11 14 1,9 2,5 II 3 3 3
4 10 0,7 1,8 I/II 2 2 2
below 4 below 0.7 I
1
no salt
required
1 1
