4 Model 390 User Guide
Installation
Installation
Your Model 390 telephone can be
installed on a desk or mounted on
the wall. To use the phone’s Call
Waiting and Caller Identification
capabilities, contact your local
Service Provider for subscription
details. Your Service Provider may
call these services by different
names.
1. Connect the handset cord
Turn the telephone over and locate
the handset jack marked
.
Insert
one end of handset cord into the
jack until it clicks into place. Then
route the handset cord through the
groove as shown in the illustration
below.
Attach the handset to the other end
of the handset cord.
2. Attach the stand
If you plan to mount the phone on
the wall, you do not need to attach
the stand; skip this step.
If you plan
to use the phone on a desk, attach
the stand by inserting the tabs on
the stand (marked with ) into the
slots on the bottom of the telephone
(A). For a higher viewing angle, use
the slots marked
. For a lower
viewing angle, use the slots marked
. Then rotate the stand towards
the phone until it snaps into place
(B).
3. Connect the cords
If you attached the stand to install
the phone on a desk,
route both the
phone cord and power adapter cord
through the opening in the stand.
Insert the phone cord into the slot
on the back of the telephone marked
until it clicks into place. Insert the
power cord into the power jack
marked
.
Note:
You should connect the
power adaptor to a surge protector
or power bar.
4. Press the cords into grooves
Press the cords into two of the
grooves provided on the bottom the
stand. This will allow the stand to
sit flat on a desk surface.
5. Install the phone
If you have installed the stand and
are using the phone on a desk:
Simply turn the telephone over so it
3
4
Power Adaptor
Phone cord
Stand
Line grooves
A
B
1
2
Handset cord
Handset
Handset groove
